Cheap One Chip Resetter for Canon PGI-5 and CLI-8 Ink Cartridges used

Customer Ratings:

Good purchase, I Like a product that Works as advertised and is easy to use. Can't get better than that! Reset all my cartridges in just a few seconds. Price was very good and even included the internal battery which is easy to replace if ever needed.

Click Here For Most Helpful Customer Reviews >>

Works on Canon IP4500 ink tanks. I had to wiggle the tank a bit to get the led to stay on and hold it steady for the required 5 to 8 seconds to reset the chip. On a couple of tanks I had to repeat the process a couple of times but it did eventually work. It is a bit tricky to get the led to light up and stay lit but for for the price, it is well worth it to me.

Best Deals for One Chip Resetter for Canon PGI-5 and CLI-8 Ink Cartridges used

I had my doubts if this widget worked. I can say on my Pixma 9000 after refilling the reservoir, hold the cartridge as directed on the widget, the light turns on, hold for a count of 5 and bada-bing it is like a new cartridge.

Honest reviews on One Chip Resetter for Canon PGI-5 and CLI-8 Ink Cartridges used

Delivered to Australia. It has a removable insert for regular size cartridges that can be removed for the bigger PGI-5 cartridge.

Red Light flashes to indicate that the chip has been reset. Even if it isn't completely full. 13.6ml CLI-8, 26ml PGI-5.

This product completes my kit of ink, syringes for ink(that evidently came with needles for ink please check with supplier to save on cost), plugs for self made DIY holes in cartridges. You can buy a screw tool that will put a hole in your cartridges if times important to you, however I use a regular size nail & hammer it in over the area for the hole for the PGI-5.

Check guides on youtube for more info. With the CLI-8, its a little bit more temperamental & after using a nail to plot the hole, I use a decent size thread screw & screw it in. Ideally the socket screw with a good size thread, will be right but it is important to compare the screw thread with the plug. WARNING!!! make sure plugs are all the way in, otherwise when the printer slides into its covered position (compartment, ideal for transport as it presents less resistance[movability]), if the plug isn't all the way in, then it will cause problems with your printer. Ive experienced this expensive mistake & am now faced with disassembling the printer to tighten screws & replace screws if required, if it is only minor damage caused by the stress of not creating a big enough hole for 1 plug.

Please note This is additional information for use with this device & is not included with this device its self, which does not present any issues, apart from the smaller slot for the CLI-8 not being interlocking with the device, which would only be relevant if you had other people in your work environment using it, who could potentially lose it, or if your clustered because of your lack of time management skills & it doesn't present a problem to me, even being in my junk room (because I am organised), however you could alternatively use tape.

Find helpful customer reviews and review ratings for One Chip Resetter for Canon PGI-5 and CLI-8 Ink Cartridges used

This product does exactly as it says and resets Canon ink cartridges. Works well. I would absolutely but another one if ever needed.